Selection Plan
The selection plan is used to configure the behavior of the Telephone. When elements are transferred to the visualization, an additional service is started.
Note: Note the channel licensing of the telephone.
Configuration
The configuration is done in the Node Editor. This simplifies the configuration, but it should be noted that invalid constructs can also be created.
To add a new node element, you can right-click on the surface or place an output or input on it using drag&drop.
Calculation is always done from left to right, then from top to bottom, relative to the position of the node elements.
Each output can be connected with each input any number of times. Looping back is also possible. However, this should only be used consciously. If an endless loop occurs, the elements are stacked 50-times.
All elements and their properties are explained in more detail in the chapter below.