KEBA KeContact

The KEBA KeContact interface communicates with a KEBA charging station.

Attention: This interface is currently in the beta phase. This means that not all functions have been tested or completed.

• Values cannot be sent
• The communication may not be fully tested.

Requirements

• KeContact P20 with firmware 2.5 or higher
• KeContact P30 c-series or x-series with firmware 3.05 or higher
• BMW wallbox with firmware 3.05 or higher
• DIP switch DSW1.3 must be set to ON

Tip: The latest firmware can be found here: https://www.keba.com/en/emobility/service-support/downloads/Downloads

Functionality

Unlike intended, Antcas Control only communicates unidirectionally via UDP/IP with a charging station. This brings advantages in terms of data security and reliability.

Variables

Which commands are supported depends on the variant used.